|
Post by littlebearmtnmusic on Jan 12, 2014 6:14:18 GMT
Good Evening,
I'm having problems getting ASIO4All (v2.10) to recognize all 4 input channels from THR10 amplifier. The THR10 provides a wet signal (with modeling and effects) on channels 1 and 2 and a dry/DI signal on channels 3 and 4. The ASIO4All control panel only shows the THR10 input channels 1 and 2 This appears to be the last of the "connectivity" issues I need to resolve before I start tuning buffers and latency.
I have the following devices installed under XP
- Reaper Version 4.5.4
- Komplete Audio 6 with mfg provided driver (ASIO4all is able to see all input and output channels)
- THR10 using the Steinberg USB driver provided by Yamaha (ASIO4all sees the two output channels but only the first 2 of the 4 input channels)
Reading the various posts, it appears this may not be the only case where ASIO4All is unable to recognize more than 2 channels from Steinberg drivers. I was wondering if any of the changes in the current beta version (2.11) are meant to address this issue, or if this is a problem that will need to be addressed by Yamaha/Steinberg.
Any help and or advice would be most appreciated.
|
|